The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during battery state sensor removal/installation are shown below.
1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
64718C
2.REMOVE LUGGAGE TRIM SERVICE HOLE COVER
28850C
3.REMOVE BATTERY STATE SENSOR ASSEMBLY
Remove the nut and disconnect the No.2 frame wire from the battery state sensor assembly.
When disconnecting the engine wire, some systems need to be initialized after the engine wire is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
Loosen the nut and remove the battery state sensor assembly from the auxiliary battery.
Disconnect the battery state sensor assembly connector.