Home › Engine / Hybrid System › A25A-FXS (ENGINE CONTROL) › SFI SYSTEM (w/o Canister Pump Module) › from 2019.10
RM33C0E _51 Engine / Hybrid System _065419 A25A-FXS ENGINE CONTROL _0331447 SFI SYSTEM(w/o Canister Pump Module) M

A25A-FXS ENGINE CONTROL  SFI SYSTEM(w/o Canister Pump Module)  REGISTRATION  


CAUTION / NOTICE / HINT

PROCEDURE

Hide 1. VIN or FRAME NUMBER

NOTICE:

The Vehicle Identification Number (VIN) or frame number must be written to a replacement ECM.


a.

DESCRIPTION

HINT:

This registration section consists of 2 parts: Read VIN or Frame Number and Write VIN or Frame Number.


i.

Read VIN or Frame Number: This procedure allows the VIN or frame number stored in the ECM to be read in order to confirm that the VINs or frame numbers, provided on the vehicle body and stored in the vehicle ECM, are the same.


ii.

Write VIN or Frame Number: This procedure allows the VIN or frame number to be written to the ECM. If the ECM is replaced, or the ECM VIN or frame number and vehicle VIN or frame number do not match, the VIN or frame number can be registered, or overwritten in the ECM by following this procedure.



b.

READ VIN OR FRAME NUMBER

i.

Confirm the vehicle VIN or frame number.


ii.

Connect the GTS to the DLC3.


iii.

Turn the power switch on (IG).


iv.

Turn the GTS on.


v.

Enter the following menus: Powertrain / Engine / Utility / VIN / VIN Read.

Powertrain > Engine > Utility
Tester Display
VIN
50005 372 2384

vi.

According to the display on the GTS, read the frame number or VIN stored in the ECM.



c.

WRITE VIN OR FRAME NUMBER

i.

Confirm the vehicle VIN or frame number.


ii.

Connect the GTS to the DLC3.


iii.

Turn the power switch on (IG).


iv.

Turn the GTS on.


v.

Enter the following menus: Powertrain / Engine / Utility / VIN / VIN Write.

Powertrain > Engine > Utility
Tester Display
VIN
50005 372 2384

vi.

According to the display on the GTS, write the vehicle frame number or VIN to the ECM.



Hide 2. GPF DEPOSITION VALUES

HINT:

These functions store and write the volumes of accumulated ash (metal oxide) and PM (Particulate Matter) that are recorded when replacing the ECM.


a.

GPF DEPOSITION VALUES SAVE

HINT:

This function stores the volumes of accumulated ash and PM recorded by the ECM.


i.

Connect the GTS to the DLC3.


ii.

Turn the power switch on (IG).


iii.

Turn the GTS on.


iv.

Enter the following menus: Powertrain / Engine / Utility / GPF Deposition Values Save.

Powertrain > Engine > Utility
Tester Display
GPF Deposition Values Save
50005 372 4508

v.

According to the display on the GTS, store the volumes of accumulated ash and PM to the GTS.



b.

GPF DEPOSITION VALUES WRITE

HINT:

This function writes the volumes of accumulated ash and PM stored in the GTS.


i.

Connect the GTS to the DLC3.


ii.

Turn the power switch on (IG).


iii.

Turn the GTS on.


iv.

Enter the following menus: Powertrain / Engine / Utility / GPF Deposition Values Write.

Powertrain > Engine > Utility
Tester Display
GPF Deposition Values Write
50005 372 4509

v.

According to the display on the GTS, write the volumes of accumulated ash and PM to the ECM.