Home › Vehicle Exterior › VEHICLE PROXIMITY NOTIFICATION SYSTEM › VEHICLE PROXIMITY NOTIFICATION SYSTEM (w/ Vehicle Approaching Speaker Switch) › 2019.10–2020.08
RM33C0E _59 Vehicle Exterior _074891 VEHICLE PROXIMITY NOTIFICATION SYSTEM _0363660 VEHICLE PROXIMITY NOTIFICATION SYSTEM(w/ Vehicle Approaching Speaker Switch) C

VEHICLE PROXIMITY NOTIFICATION SYSTEM  VEHICLE PROXIMITY NOTIFICATION SYSTEM(w/ Vehicle Approaching Speaker Switch)  B1350  Speaker Circuit  


DESCRIPTION

The vehicle approaching speaker assembly circuit consists of the vehicle approaching speaker controller and vehicle approaching speaker assembly.

This DTC is stored when a malfunction is detected in the vehicle approaching speaker assembly circuit.

DTC No. Detection Item DTC Detection Condition Trouble Area
B1350 Speaker Circuit
Detection Condition:

The power switch is on (IG).


Malfunction Status:

Either of the following conditions is met:

-

When sound output voltage is being monitored by the ECU, the auxiliary battery voltage is 10 V or more and warning sound being produced, a short in the vehicle approaching speaker circuit occurs for 1 second or more.

-

When sound output voltage is being monitored by the ECU and the warning sound is not being produced, an open in the vehicle approaching speaker circuit occurs for 5 seconds or more.



·

Vehicle approaching speaker controller

·

Vehicle approaching speaker assembly

·

Harness or connector



WIRING DIAGRAM

E369729E07
3.76,2.031 5.625,2.469 1.865,0.438 10 false Vehicle Approaching Speaker Controller 3.76,1.854 4.219,2.052 0.458,0.198 10 false K160 4.188,0.99 4.646,1.188 0.458,0.198 10 false SP+ 4.188,1.375 4.646,1.573 0.458,0.198 10 false SP- 2.531,1.073 2.99,1.271 0.458,0.198 10 false + 2.531,1.469 2.99,1.667 0.458,0.198 10 false - 1.51,2.01 3.375,2.448 1.865,0.438 10 false Vehicle Approaching Speaker Assembly 1.51,1.833 1.969,2.031 0.458,0.198 10 false A77 2.76,0.969 3.219,1.167 0.458,0.198 10 false 1 2.771,1.344 3.229,1.542 0.458,0.198 10 false 2 3.99,0.969 4.208,1.198 0.219,0.229 10 false 3 3.99,1.365 4.198,1.552 0.208,0.188 10 false 8

PROCEDURE

1.INSPECT VEHICLE APPROACHING SPEAKER ASSEMBLY

OK

2.CHECK HARNESS AND CONNECTOR (VEHICLE APPROACHING SPEAKER ASSEMBLY - VEHICLE APPROACHING SPEAKER CONTROLLER)

NG

2.CHECK HARNESS AND CONNECTOR (VEHICLE APPROACHING SPEAKER ASSEMBLY - VEHICLE APPROACHING SPEAKER CONTROLLER)
a.

Disconnect the K160 vehicle approaching speaker controller connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A77-1 (+) - K160-3 (SP+) Always Below 1 Ω
A77-2 (-) - K160-8 (SP-) Always Below 1 Ω
A77-1 (+) or K160-3 (SP+) - Body ground Always 10 kΩ or higher
A77-2 (-) or K160-8 (SP-) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR