CHECK VEHICLE APPROACHING SPEAKER CONTROLLER
Disconnect the K161 vehicle approaching speaker controller connector.
Measure the voltage and resistance according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| K161-1 (IG) - Body ground | LA-B - Body ground | IG power supply | Power switch on (IG) | 11 to 14 V |
| Power switch off | Below 1 V | |||
| K161-6 (GND) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
Connect the K161 vehicle approaching speaker controller connector.
Measure the check for pulses according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| K161-7 (SP+) - K161-8 (SP-) | GR - G | Vehicle approaching speaker output | Vehicle approaching speaker operating | A waveform synchronized with the sound is output.
(See Waveform 1) |
| K161-3 (CANH) - K161-6 (GND) | Y - W-B | CAN communication line | Power switch on (IG) | Pulse generation |
| K161-4 (CANL) - K161-6 (GND) | W - W-B | CAN communication line | Power switch on (IG) | Pulse generation |
Waveform 1
| Item | Condition |
|---|---|
| Tester Connection | K161-7 (SP+) - K161-8 (SP-) |
| Tool Setting | 1 V/DIV., 500 ms./DIV. |
| Condition | Vehicle approaching speaker operating |