Home › Vehicle Exterior › VEHICLE PROXIMITY NOTIFICATION SYSTEM › VEHICLE PROXIMITY NOTIFICATION SYSTEM (w/o Vehicle Approaching Speaker Switch) › from 2019.10
RM33C0E _59 Vehicle Exterior _074891 VEHICLE PROXIMITY NOTIFICATION SYSTEM _0436298 VEHICLE PROXIMITY NOTIFICATION SYSTEM(w/o Vehicle Approaching Speaker Switch) C

VEHICLE PROXIMITY NOTIFICATION SYSTEM  VEHICLE PROXIMITY NOTIFICATION SYSTEM(w/o Vehicle Approaching Speaker Switch)  B1350  Speaker Circuit  


DESCRIPTION

The vehicle approaching speaker assembly circuit consists of the vehicle approaching speaker controller and vehicle approaching speaker assembly.

This DTC is stored when a malfunction is detected in the vehicle approaching speaker assembly circuit or vehicle approaching speaker controller.

DTC No. Detection Item DTC Detection Condition Trouble Area
B1350 Speaker Circuit
Detection condition(1):

The power switch is on (IG).


Detection condition(2):

IG power source voltage is 10 V or more.


Malfunction status(1):

When ECU output sound signal is being monitored with warning sound not being output, a speaker circuit open, short or short to ground is detected.


Malfunction status(2):

When vehicle proximity warning sound output conditions are met, an internal malfunction is continuously detected in the vehicle approaching speaker controller.


Malfunction duration(1):

6 seconds or more


Malfunction duration(2):

3 seconds or more


·

Vehicle approaching speaker controller

·

Vehicle approaching speaker assembly

·

Harness or connector



WIRING DIAGRAM

E402276E56
1.094,1.917 1.552,2.115 0.458,0.198 10 false A77 1.083,2.073 2.375,2.583 1.292,0.51 10 false Vehicle Approaching Speaker Assembly 4.75,1.938 5.208,2.135 0.458,0.198 10 false K161 4.76,2.094 6.042,2.563 1.281,0.469 10 false Vehicle Approaching Speaker Controller 2.104,0.969 2.563,1.167 0.458,0.198 10 false 2 2.104,1.375 2.563,1.573 0.458,0.198 10 false 1 4.75,0.99 5.208,1.188 0.458,0.198 10 false 7 4.75,1.375 5.208,1.573 0.458,0.198 10 false 8 4.938,1.073 5.396,1.271 0.458,0.198 10 false SP+ 4.938,1.49 5.396,1.688 0.458,0.198 10 false SP-

PROCEDURE

1.INSPECT VEHICLE APPROACHING SPEAKER ASSEMBLY

OK

2.CHECK HARNESS AND CONNECTOR (VEHICLE APPROACHING SPEAKER ASSEMBLY - VEHICLE APPROACHING SPEAKER CONTROLLER)

NG

2.CHECK HARNESS AND CONNECTOR (VEHICLE APPROACHING SPEAKER ASSEMBLY - VEHICLE APPROACHING SPEAKER CONTROLLER)
a.

Disconnect the K161 vehicle approaching speaker controller connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A77-2 - K161-7 (SP+) Always Below 1 Ω
A77-1 - K161-8 (SP-) Always Below 1 Ω
A77-2 or K161-7 (SP+) - Body ground Always 10 kΩ or higher
A77-1 or K161-8 (SP-) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR