Home › Engine / Hybrid System › A25A-FXS (COOLING) › THERMOSTAT › from 2020.08
RM33C0E _51 Engine / Hybrid System _065424 A25A-FXS COOLING _0328475 THERMOSTAT A

A25A-FXS COOLING  THERMOSTAT  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 16031 1.INSTALL WATER INLET WITH THERMOSTAT SUB-ASSEMBLY

a.

Install a new gasket to the water inlet with thermostat sub-assembly.

HINT:

Be sure to clean the contact surfaces.



b.

Using an 8 mm socket wrench, install the water inlet with thermostat sub-assembly with the 2 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


c.

Connect the No. 7 water by-pass hose to the water inlet with thermostat sub-assembly and slide the clip to secure it.


Hide 3.ADD ENGINE COOLANT (for Engine)

Hide 4.INSPECT FOR COOLANT LEAK (for Engine)