When the forward recognition camera is replaced with a new one, the new forward recognition camera attempts to store the vehicle information received from the hybrid vehicle control ECU assembly. If the vehicle information stored in the forward recognition camera is different from that stored in the hybrid vehicle control ECU assembly, DTC C1AAC is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1AAC | Vehicle Information Unmatched | After the power switch is turned on (IG) for 3 seconds or more, the vehicle information received from the hybrid vehicle control ECU assembly and that stored in the forward recognition camera do not match for 5 seconds or more. | ·
Hybrid control system ·
Motor generator control system ·
Forward recognition camera |
When replacing the forward recognition camera, always replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle. As a result, a DTC may be stored.
If the forward recognition camera has been replaced with a new one, be sure to perform forward recognition camera adjustment.
Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>ADJUSTMENT (SEQUENTIAL RECOGNITION)
If DTC C1AAC is stored, the hybrid control system may be malfunctioning. Check for DTCs related to the hybrid control system first.
Check for DTCs.
| Result | Proceed to |
|---|---|
| Hybrid control system DTCs are not output | A |
| Hybrid control system DTCs are output | B |
A
B
for NICKEL METAL HYDRIDE BATTERY: Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM (for NICKEL METAL HYDRIDE BATTERY)>HOW TO PROCEED WITH TROUBLESHOOTING
for LITHIUM-ION BATTERY: Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM (for LITHIUM-ION BATTERY)>HOW TO PROCEED WITH TROUBLESHOOTING
If DTC C1AAC is stored, the motor generator control system may be malfunctioning. Check for DTCs related to the motor generator control system first.
Check for DTCs.
| Result | Proceed to |
|---|---|
| Motor generator control system DTCs are not output | A |
| Motor generator control system DTCs are output | B |
A
B
for NICKEL METAL HYDRIDE BATTERY: Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>MOTOR GENERATOR CONTROL SYSTEM (for NICKEL METAL HYDRIDE BATTERY)>HOW TO PROCEED WITH TROUBLESHOOTING
for LITHIUM-ION BATTERY: Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>MOTOR GENERATOR CONTROL SYSTEM (for LITHIUM-ION BATTERY)>HOW TO PROCEED WITH TROUBLESHOOTING
Clear the DTCs.
Perform the following procedure.
If the following procedure is not performed, the previously output DTC cannot be detected.
Turn the power switch on (IG) and wait 8 seconds or more.
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTC C1AAC is not output | A |
| DTC C1AAC is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B