Home › Vehicle Interior › PRE-COLLISION › PRE-COLLISION SYSTEM › 2020.08–2021.02
RM33C0E _58 Vehicle Interior _065461 PRE-COLLISION _0332154 PRE-COLLISION SYSTEM C

PRE-COLLISION  PRE-COLLISION SYSTEM  C1A63  Other System Malfunction  


DESCRIPTION

If the hybrid vehicle control ECU assembly detects a malfunction in the hybrid control system or motor generator control system, it outputs a malfunction signal to the millimeter wave radar sensor assembly via CAN communication and DTC C1A63 is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1A63 Other System Malfunction With the power switch on (IG), the millimeter wave radar sensor assembly receives an accelerator pedal position sensor malfunction signal from the hybrid vehicle control ECU assembly for approximately 2 seconds or more.
·

Hybrid control system

·

Motor generator control system



PROCEDURE

1.GO TO HYBRID CONTROL SYSTEM AND MOTOR GENERATOR CONTROL SYSTEM
HINT:

If DTC C1A63 is output by the pre-collision system, perform troubleshooting for the hybrid control system and motor generator control system.



Result:
Proceed to
NEXT



NEXT

END