Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › GRILLE SHUTTER SYSTEM › from 2020.08
RM33C0E _59 Vehicle Exterior _065474 EXTERIOR PANELS / TRIM _0331705 GRILLE SHUTTER SYSTEM J

EXTERIOR PANELS / TRIM  GRILLE SHUTTER SYSTEM  Grille Shutter is Half Opened/Closed  


DESCRIPTION

The grille shutter of the radiator shutter sub-assembly may only half open/close when dirty due to foreign matter, snow, mud, etc.

CAUTION / NOTICE / HINT

NOTICE:
·

Before performing troubleshooting, change the grille shutter control mode to maintenance mode.

w/ Canister Pump Module: Click hereEngine / Hybrid System>A25A-FXS (ENGINE CONTROL)>SFI SYSTEM (w/ Canister Pump Module)>INITIALIZATION

w/o Canister Pump Module: Click hereEngine / Hybrid System>A25A-FXS (ENGINE CONTROL)>SFI SYSTEM (w/o Canister Pump Module)>INITIALIZATION

·

If the radiator shutter assembly has been replaced with a new one, perform initialization and change the grille shutter control mode.

w/ Canister Pump Module: Click hereEngine / Hybrid System>A25A-FXS (ENGINE CONTROL)>SFI SYSTEM (w/ Canister Pump Module)>INITIALIZATION

w/o Canister Pump Module: Click hereEngine / Hybrid System>A25A-FXS (ENGINE CONTROL)>SFI SYSTEM (w/o Canister Pump Module)>INITIALIZATION



PROCEDURE

1.PERFORM UTILITY USING GTS (SWITCH GRILLE SHUTTER CONTROL MODE)
a.

According to the display on the GTS, change the grille shutter control mode from normal mode to maintenance mode.

Powertrain > Engine > Utility
Tester Display
Switch Grille Shutter Control Mode
50005 372 5672

Result:
Proceed to
NEXT



NEXT

2.CHECK FOR GRILLE SHUTTER (FOREIGN MATTER AND ICE)
2.CHECK FOR GRILLE SHUTTER (FOREIGN MATTER AND ICE)
a.

Check the area around the shutters and the links of the grille shutter for foreign matter and ice.

OK:

The radiator shutter sub-assembly is free of foreign matter and ice.



Result:
Proceed to
OK
NG



OK

3.INITIALIZE GRILLE SHUTTER SYSTEM

NG

6.REMOVE FOREIGN MATTER OR ICE (CLEAN GRILLE SHUTTER)
3.INITIALIZE GRILLE SHUTTER SYSTEM
a.

According to the display on the GTS, perform initialization (nominal torque).

Powertrain > Engine > Utility
Tester Display
Grille Shutter Initialization
50005 372 5673

Result:
Proceed to
NEXT



NEXT

4.PERFORM ACTIVE TEST USING GTS
4.PERFORM ACTIVE TEST USING GTS
a.

Using the GTS, operate the grille shutter by performing an Active Test and remove any foreign matter.

HINT:

When foreign matter is jammed with the grille shutter open, perform a close operation. When foreign matter is jammed with the grille shutter closed, perform an open operation.


Powertrain > Engine > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Control the Grille Shutter Control the swing grille actuator assembly 0% (open) to 100% (close) Perform this test when the following conditions are met:
·

Ignition switch ON.

·

Auxiliary battery voltage is 10.5 to 16 V.


Powertrain > Engine > Active Test
Tester Display
Control the Grille Shutter
50004 372 42033

Result:
Proceed to
NEXT



NEXT

5.READ VALUE USING GTS (GRILLE SHUTTER CONTROL MODE)
5.READ VALUE USING GTS (GRILLE SHUTTER CONTROL MODE)
a.

According to the display on the GTS, change the grille shutter control mode from maintenance mode to normal mode.

Powertrain > Engine > Utility
Tester Display
Switch Grille Shutter Control Mode
50005 372 5672

b.

Read the value displayed on the GTS.

Powertrain > Engine > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Grille Shutter Control Mode Grille shutter control mode status Normal or Maintenance Normal: Normal mode
Maintenance: Maintenance mode
-
Powertrain > Engine > Data List
Tester Display
Grille Shutter Control Mode
50003 372 1304
OK:

Normal is displayed.



Result:
Proceed to
NEXT



NEXT

END

6.REMOVE FOREIGN MATTER OR ICE (CLEAN GRILLE SHUTTER)
a.

Remove any foreign matter and/or ice from the area around the shutters and the links of the grille shutter.


Result:
Proceed to
NEXT



NEXT

5.READ VALUE USING GTS (GRILLE SHUTTER CONTROL MODE)