The hybrid vehicle control ECU assembly controls the back-up lights via the BKUP LP relay.
Inspect the fuses for circuits related to this system before performing the following procedure.
Before replacing the hybrid vehicle control ECU assembly, refer to Service Bulletin.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
Check for DTCs.
| Result | Proceed to |
|---|---|
| Hybrid control system DTCs are not output | A |
| Hybrid control system DTCs are output | B |
A
B
for NICKEL METAL HYDRIDE BATTERY: Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM (for NICKEL METAL HYDRIDE BATTERY)>DIAGNOSTIC TROUBLE CODE CHART
for LITHIUM-ION BATTERY: Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM (for LITHIUM-ION BATTERY)>DIAGNOSTIC TROUBLE CODE CHART
Disconnect the 3B instrument panel junction block assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3B-3 - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the 3C instrument panel junction block assembly connector.
Disconnect the A29 hybrid vehicle control ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A29-2 (BL) - 3C-19 | Always | Below 1 Ω |
| A29-2 (BL) or 3C-19 - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Component with harness connected
(Instrument Panel Junction Block Assembly) |
Connect the A29 hybrid vehicle control ECU assembly connector.
Connect the 3B and 3C instrument panel junction block assembly connectors.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3C-19 - Body ground | Power switch off, shift lever not in R | Below 1 V |
| 3C-19 - Body ground | Power switch on (IG), shift lever in R | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Component with harness connected
(Instrument Panel Junction Block Assembly) |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3D-10 - Body ground | Power switch off, shift lever not in R | Below 1 V |
| 3D-10 - Body ground | Power switch on (IG), shift lever in R | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG