The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear seat airbag assembly removal/installation are shown below.
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
Wear protective gloves. Sharp areas on the parts may injure your hands.
If a rear seat airbag assembly has been deployed, replace the rear seat airbag assembly, rear side seatback frame sub-assembly, rear side seatback pad and rear side seatback cover sub-assembly with the necessary parts in accordance with the extent of the collision damage.
Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for Reclining Seat Type)>DISASSEMBLY
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
64718C
2.REMOVE LUGGAGE TRIM SERVICE HOLE COVER
3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
Click hereGeneral>MAINTENANCE>AUXILIARY BATTERY>REMOVAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
73350C
4.DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY
5.REMOVE REAR SEAT CUSHION ASSEMBLY
72693
6.REMOVE REAR SEAT CUSHION LOCK HOOK
71940A
7.REMOVE REAR SEAT HEADREST ASSEMBLY
72996A
8.REMOVE REAR SEATBACK COVER
9.REMOVE REAR SEATBACK ASSEMBLY
62332A
10.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP
Disconnect the rear door opening trim weatherstrip to the extent that allows the removal of the rear side seatback assembly.
11.REMOVE REAR SIDE SEATBACK ASSEMBLY
12.REMOVE REAR SIDE SEATBACK COVER WITH PAD
73940A
13.REMOVE REAR SEAT AIRBAG ASSEMBLY
|
Deployment Side |
When storing the rear seat airbag assembly, keep the airbag deployment side facing upward.
Disengage the clamp.
Disconnect the wire harness from the wire harness clamp.
Remove the 2 nuts and rear seat airbag assembly.
Do not reuse the nuts.
Make sure that the rear side seatback frame sub-assembly is not deformed. If it is deformed, replace the rear side seatback frame sub-assembly with a new one.