84255
1.INSPECT STEERING HEATER SWITCH
| *a | Component without harness connected
(Steering Heater Switch) |
Remove the steering heater switch.
Click hereSteering>STEERING COLUMN>STEERING HEATER SWITCH (for LHD)>REMOVAL
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 5 (IG) - 2 (B) | Steering heater switch is pushed | Below 1 Ω |
| 5 (IG) - 2 (B) | Steering heater switch is not pushed | 10 kΩ or higher |
Indicator Inspection
Apply battery voltage to the steering heater switch and check that the indicator illuminates.
| Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 2 (B)
Battery negative (-) → Terminal 4 (E) |
Illuminates |