Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM › from 2021.02
RM33C0E _56 Audio / Visual / Telematics _065452 PARK ASSIST / MONITORING _0333742 BLIND SPOT MONITOR SYSTEM W

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  CUSTOMIZE PARAMETERS  


CUSTOMIZE BLIND SPOT MONITOR SYSTEM


a.

Customizing with the GTS

NOTICE:
·

When the customer requests a change in a function, first make sure that the function can be customized.

·

Be sure to make a note of the current settings before customizing.

·

When troubleshooting a function, first make sure that the function is set to the default setting.



i.

Connect the GTS to the DLC3.


ii.

Turn the power switch to ON.


iii.

Turn the blind spot monitor system on.


iv.

Turn the GTS on.


v.

Enter the following menus: Body Electrical / Blind Spot Monitor Master or Blind Spot Monitor Slave / Utility / Warning.


vi.

Select the setting by referring to the table below.

Warning
Tester Display Description Default Setting ECU
BSM Buzzer Volume Adjust Sets the volume of the RCTA buzzer (blind spot monitor buzzer). Medium 001:Low,011:Medium,101:High Blind Spot Monitor Sensor LH
BSM Function Switches the BSM function on and off. Valid 0:Valid,1:Invalid Blind Spot Monitor Sensor RH
BSM Mirror Indicator Brightness Sets the brightness of the indicators in the outer rear view mirror assemblies. Bright 001:Dark,101:Bright Blind Spot Monitor Sensor RH
RCTA Function Switches the RCTA function on and off.*1 ON 0:ON,1:OFF Blind Spot Monitor Sensor RH
BSM Approaching Vehicle Detection Timing Setting Sets the notification timing for vehicles approaching from behind the vehicle.*2 Middle 00:Only Blind Spot,01:Late,10:Middle,11:Early Blind Spot Monitor Sensor RH
50006 7

*1: If the RCTA function is turned off, the RCTAB function of the parking support brake system also turns off.

*2: w/ BSM Approaching Vehicle Detection Timing Setting Function




b.

Customizing with multi-information display

NOTICE:
·

When the customer requests a change in a function, first make sure that the function can be customized.

·

Be sure to make a note of the current settings before customizing.

·

When troubleshooting a function, first make sure that the function is set to the default setting.



BSM
Display Description Default Setting ECU
BSM Switches the BSM function on and off. ON ON or OFF Blind Spot Monitor Sensor RH
Brightness Sets the brightness of the indicators in the outer rear view mirror assemblies. Bright Dim or Bright Blind Spot Monitor Sensor RH
Sensitivity* Sets the notification timing for vehicles approaching from behind the vehicle. Middle Early, Middle, Late or Only Blind Spot Blind Spot Monitor Sensor RH

RCTA
Display Measurement Item Default Setting ECU
RCTA Switches the RCTA function on and off. ON ON or OFF Blind Spot Monitor Sensor RH
Volume Sets the volume of the RCTA buzzer (No. 2 clearance warning buzzer) 2 1, 2 or 3 Blind Spot Monitor Sensor LH

*: w/ BSM Approaching Vehicle Detection Timing Setting Function