Home › Engine / Hybrid System › CRUISE CONTROL › CAMERA HEATER › from 2021.02
RM33C0E _51 Engine / Hybrid System _065434 CRUISE CONTROL _0331762 CAMERA HEATER A

CRUISE CONTROL  CAMERA HEATER  INSTALLATION  


PROCEDURE

Hide 86461 1.INSTALL FORWARD RECOGNITION HOOD

NOTICE:
E453607C02
0,0 0,0 false
V100155

Inner Surface of Forward Recognition Hood


·

Do not touch the inner surface of the forward recognition hood.

·

Do not apply force to the heating element of the forward recognition hood or an open circuit may result.



a.
E453612C02
0,0 0,0 false
V100155

Heater Area
V113147

Install in this Direction (1)
V113148

Install in this Direction (2)


Engage the 2 guides and 2 claws as indicated by the arrows in the order shown in the illustration.

NOTICE:
·

Make sure that the 2 claws are engaged as shown in the illustration. Failure to do so may result in the malfunction of systems that use the forward recognition camera.

·

Do not apply force to the heating element of the forward recognition hood or an open circuit may result.




b.
E460233C02
0.896,0.24 1.375,0.24 true 0.76,1.146 0.417,0.854 0.417,0.854 1.01,0.854 true 2.302,1.896 2.396,1.719 true 3.031,1.177 2.948,1 true 3.052,1.906 2.969,1.719 true 0.667,0.156 0.896,0.344 0.229,0.188 10 true *a 0.208,0.781 0.406,0.979 0.198,0.198 10 true *b 1.25,0.781 1.396,0.948 0.146,0.167 10 true 2 0.99,1.125 1.135,1.292 0.146,0.167 10 true 1 2.188,1.885 2.385,2.083 0.198,0.198 10 true *b 2.979,1.906 3.177,2.104 0.198,0.198 10 true *b
*a Connector Clamp
*b Wire Harness Clamp
V100155

Marking Tape


With the marking tape of the wire harness in between the 2 wire harness clamps, engage the 2 wire harness clamps in the order shown in the illustration.

NOTICE:
·

Do not forcibly pull the wire harness as it may become damaged.

·

As the No. 1 forward recognition cover cannot be installed correctly if the wire harness clamps are not engaged securely, make sure to engage the wire harness clamps securely.




c.

Engage the connector clamp to install the forward recognition hood.

NOTICE:

As the No. 1 forward recognition cover cannot be installed correctly if the connector clamp is not engaged securely, make sure to engage the connector clamp securely.



d.

Connect the connector.


Hide 8646C 2.INSTALL FORWARD RECOGNITION CAMERA