Home › Vehicle Exterior › LIGHTING (EXT) › HAZARD WARNING SWITCH › from 2021.02
RM33C0E _59 Vehicle Exterior _065472 LIGHTING (EXT) _0330504 HAZARD WARNING SWITCH G

LIGHTING (EXT)  HAZARD WARNING SWITCH  INSPECTION  


PROCEDURE

Hide 84330 1.INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY

a.
E402229C03
0.813,1.635 1.198,1.229 false 1.167,1.823 1.396,1.229 false 2.094,1.656 1.979,1.219 false 2.51,1.604 2.167,1.24 false 0.208,0.167 0.406,0.323 0.198,0.156 10 false *a 1.104,1.854 1.417,2.052 0.313,0.198 10 false TB 2.073,1.688 2.385,1.885 0.313,0.198 10 false E 0.677,1.677 1.063,1.865 0.385,0.188 10 false ILL+ 2.49,1.667 2.875,1.854 0.385,0.188 10 false ILL-
*a Component without harness connected
(Hazard Warning Signal Switch Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
6 (TB) - 3 (E) Hazard warning signal switch off 10 kΩ or higher
Hazard warning signal switch on Below 1 Ω


If the result is not as specified, replace the hazard warning signal switch assembly.


b.

Illumination Inspection

i.

Apply auxiliary battery voltage to the hazard warning signal switch assembly and check that the switch illuminates.

OK:
Condition Specified Condition
Auxiliary battery positive (+) → Terminal 7 (ILL+)
Auxiliary battery negative (-) → Terminal 2 (ILL-)
Illuminates


If the result is not as specified, replace the hazard warning signal switch assembly.