The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during vehicle approaching speaker controller removal/installation are shown below.
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
73900
1.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
86572
2.REMOVE VEHICLE APPROACHING SPEAKER CONTROLLER
| *a | Nut |
| *b | Connector |
Remove the nut.
Disengage the guide.
Disconnect the connector to remove the vehicle approaching speaker controller.