When a malfunction is detected between various ECUs and sensors, these DTCs are stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U012587 | Lost Communication with Multi-axis Acceleration Sensor Module Missing Message | 3 seconds or more after the power switch is turned on (IG), while the vehicle is being driven at 1 km/h or 1 mph or more, a communication error between the airbag sensor assembly and the forward recognition camera is detected for approximately 5 seconds or more. | CAN communication system |
| U012687 | Lost Communication with Steering Angle Sensor Module Missing Message | 3 seconds after the power switch is turned on (IG), a communication error between the steering sensor and the forward recognition camera is detected for approximately 5 seconds or more. | CAN communication system |
| U012987 | Lost Communication with Brake System Control Module Missing Message | 3 seconds after the power switch is turned on (IG), a communication error between the skid control ECU (brake booster with master cylinder assembly) and the forward recognition camera is detected for approximately 5 seconds or more. | CAN communication system |
| U014087 | Lost Communication with Body Control Module Missing Message | 3 seconds after the power switch is turned on (IG), a communication error between the main body ECU (multiplex network body ECU) and the forward recognition camera is detected for approximately 5 seconds or more. | CAN communication system |
| U029387 | Lost Communication with Hybrid Powertrain Control Module Missing Message | 3 seconds after the power switch is turned on (IG), while the vehicle is being driven at 1 km/h or 1 mph or more, a communication error between the hybrid vehicle control ECU assembly and the forward recognition camera is detected for approximately 5 seconds or more. | CAN communication system |
Clear the DTCs.
Make sure that the DTC detection conditions are met.
If the detection conditions are not met, the system cannot detect the malfunction.
Check for DTCs.
| Result | Proceed to |
|---|---|
| CAN communication system DTC is not output | A |
| CAN communication system DTC is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING