Home › Vehicle Interior › PRE-COLLISION › PRE-COLLISION SYSTEM › from 2021.02
RM33C0E _58 Vehicle Interior _065461 PRE-COLLISION _0332154 PRE-COLLISION SYSTEM C

PRE-COLLISION  PRE-COLLISION SYSTEM  C142571  Stop Light Relay Actuator Stuck  


DESCRIPTION

The skid control ECU (brake booster with master cylinder assembly) sends a stop light operation request signal to the stop light control relay (stop light switch assembly). When the skid control ECU (brake booster with master cylinder assembly) detects a malfunction relating to the stop light circuit, the forward recognition camera is notified via CAN communication, and C142571 is output.

DTC No. Detection Item DTC Detection Condition Trouble Area
C142571 Stop Light Relay Actuator Stuck Once 3 seconds elapse after turning the power switch on (IG), the system receives a stop light circuit malfunction signal from the skid control ECU (brake booster with master cylinder assembly) for approximately 1 second or more. Electronically controlled brake system

PROCEDURE

1.CHECK ELECTRONICALLY CONTROLLED BRAKE SYSTEM
a.

Check electronically controlled brake system.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING

HINT:

When C142571 is detected by the pre-collision system, C1380 may also be detected in the electronically controlled brake system. Therefore, check the electronically controlled brake system first when C142571 is detected.



Result:
Proceed to
NEXT



NEXT

END