Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM (for eCall) › from 2021.02
RM33C0E _56 Audio / Visual / Telematics _078700 TELEMATICS _0387130 TELEMATICS SYSTEM(for eCall) D

TELEMATICS  TELEMATICS SYSTEM(for eCall)  OPERATION CHECK  


ENTER TEST MODE


HINT:
·

By performing a system check, it is possible to check the operation of the telematics transceiver.

·

Make sure to perform a test mode after troubleshooting the telematics system.



a.

Turn the ignition switch to ON and wait for 60 seconds with the vehicle stopped.


b.

Turn the taillights on and off at an interval of 10 seconds or less as follows:

HINT:
·

These operations should be performed 10 times or more, until both the red and green indicator lights of the manual (SOS) switch are flashing.

·

Turning the taillights on and off can be confirmed by the dimming of the green indicator of the manual (SOS) switch.



for Light Control Switch without Off Position:

With the automatic light control sensor exposed to light, turn the light control switch from "AUTO" to "Tail" and back again repeatedly.

(Example: AUTO → Tail → AUTO → Tail . . . .)


for Light Control Switch without Off Position (if the above procedure cannot be completed successfully):

With the automatic light control sensor exposed to light, use an opaque cover to repeatedly cover and uncover the automatic light control sensor.

(Example: Uncover → Cover → Uncover → Cover . . . .)



c.
E338332C03
1.094,1.927 1.344,1.927 1.344,1.927 1.344,1.51 true 2.354,1.927 2.104,1.927 2.104,1.927 2.104,1.51 true 0.875,1.833 1.115,2.063 0.24,0.229 10 false *a 2.417,1.844 2.656,2.073 0.24,0.229 10 false *b
*a Manual (SOS) Switch Green Indicator
*b Manual (SOS) Switch Red Indicator


Check that the manual (SOS) switch indicators begin blinks 5 times over 10 seconds and then turn off. Push the manual (SOS) switch for less than 3 seconds within 15 seconds after the indicators begin to blink to enter test mode.



PERFORM SYSTEM CHECK


a.

Enter test mode.

HINT:

The manual (SOS) switch indicator (green) will blink 3 times to indicate that test mode has been entered.



b.

Speak into the communication telematics box and confirm that your voice can be heard from the communication telematics box.