The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear door courtesy light switch assembly removal/installation are shown below.
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
Use the same procedure for the RHD and LHD.
The following procedure is for the LHD.
1. PRECAUTION (w/ Rear Seat Side Airbag)
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
64718C
2.REMOVE LUGGAGE TRIM SERVICE HOLE COVER (w/ Rear Seat Side Airbag)
3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL (w/ Rear Seat Side Airbag)
Click hereGeneral>MAINTENANCE>AUXILIARY BATTERY>REMOVAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
If an airbag deploys for any reason, it may cause a serious injury.
73350C
4.DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY (for Fold Down Seat Type)
5.REMOVE REAR SEAT CUSHION ASSEMBLY (for Fold Down Seat Type)
72693
6.REMOVE REAR SEAT CUSHION LOCK HOOK (for Fold Down Seat Type)
62332A
7.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP (for Fold Down Seat Type)
8.REMOVE REAR SIDE SEATBACK ASSEMBLY (for Fold Down Seat Type)
71940A
9.REMOVE REAR SEAT HEADREST ASSEMBLY (for Reclining Seat Type)
73350C
10.DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY (for Reclining Seat Type)
11.REMOVE REAR SEAT CUSHION ASSEMBLY (for Reclining Seat Type)
72693
12.REMOVE REAR SEAT CUSHION LOCK HOOK (for Reclining Seat Type)
72996A
13.REMOVE REAR SEATBACK COVER (for Reclining Seat Type)
14.REMOVE REAR SEATBACK ASSEMBLY (for Reclining Seat Type)
62332A
15.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP (for Reclining Seat Type)
16.REMOVE REAR SIDE SEATBACK ASSEMBLY (for Reclining Seat Type)
84234
17.REMOVE REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY
Using a T30 "TORX" socket wrench, remove the screw.
Disconnect the connector to remove the rear door courtesy light switch assembly.