CHECK PARKING BRAKE ECU (BRAKE ACTUATOR ASSEMBLY)
| *a | Front view of wire harness connector (to Parking Brake ECU (Brake Actuator Assembly)) | - | - |
Disconnect the A44 parking brake ECU (brake actuator assembly) connector.
Measure the voltage and resistance according to the value (s) in the table below.
| Terminal No. (Symbol) | Terminal Description | Condition | Specified Condition |
|---|---|---|---|
| A44-9 (BEPB) - Body ground | Parking brake Ignition supply | Power switch off | 11 to 14 V |
| A44-26 (IG) - Body ground | IG Ignition supply | Power switch on (IG) | 11 to 14 V |
| A44-2 (EGND) - Body ground | Ground | Always | Below 1 Ω |
| A44-14 (SWI1) - Body ground | Electric parking brake switch assembly | - | - |
| A44-24 (SWI2) - Body ground | Electric parking brake switch assembly | - | - |
| A44-20 (SWO1) - Body ground | Electric parking brake switch assembly | - | - |
| A44-22 (SWO2) - Body ground | Electric parking brake switch assembly | - | - |
| A44-4 (MRR+) - Body ground | Parking brake motor RH (parking brake actuator assembly RH) (+) | - | - |
| A44-3 (MRR-) - Body ground | Parking brake motor RH (parking brake actuator assembly RH) (-) | - | - |
| A44-7 (MRL+) - Body ground | Parking brake motor LH (parking brake actuator assembly LH) (+) | - | - |
| A44-8 (MRL-) - Body ground | Parking brake motor LH (parking brake actuator assembly LH) (-) | - | - |
| A44-27 (SPD) - Body ground | Vehicle speed direct input | - | - |
| A44-12 (CANH) - Body ground | CAN communication line H | - | - |
| A44-11 (CANL) - Body ground | CAN communication line L | - | - |