The parking brake ECU (brake actuator assembly) receives vehicle tilt angle information from the acceleration sensor (airbag ECU assembly) via CAN communication.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory | Note |
|---|---|---|---|---|---|
| C052062 | Multi-axis Acceleration Sensor Module "A" Signal Compare Failure | While the acceleration sensor (airbag ECU assembly) signal is judged to be stuck, starting off and stopping of vehicle occurs 16 times. | Acceleration sensor (airbag ECU assembly) | DTC stored | An electric parking brake system malfunction is displayed on the combination meter assembly. |
| C052096 | Multi-axis Acceleration Sensor Module "A" Component Internal Failure | An error signal is sent from acceleration sensor (airbag ECU assembly) for approximately 0.3 seconds. | Acceleration sensor (airbag ECU assembly) | DTC stored | An electric parking brake system malfunction is displayed on the combination meter assembly. |
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output | B |
A
B
Clear the DTCs.
Turn the power switch off.
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTCs are output | A |
| DTCs are not output | B |
A
B
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING