This circuit is the power source circuit to operate the television camera controller. The television camera controller controls the panoramic view monitor system.
Inspect the fuse for circuits related to this system before performing the following procedure.
If the television camera controller does not operate due to a power source problem, other system DTCs may be stored due to a CAN communication interruption.
Disconnect the R125 television camera controller connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| R125-4 (GND1) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the R125 television camera controller connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| R125-1 (+B) - R125-4 (GND1) | Ignition switch off | 11 to 14 V |
| R125-2 (ACC) - R125-4 (GND1) | Ignition switch ACC | 11 to 14 V |
| Ignition switch off | Below 1 V | |
| R125-3 (IG) - R125-4 (GND1) | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG