These DTCs are stored if there is a malfunction in the CAN communication system connected to the rear television camera assembly.
If CAN communication system DTCs are stored, they may also be stored in other systems.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| U1110 | Lost Communication with Intuitive Parking Assist Module | Lost communication with clearance warning ECU assembly | CAN communication system | Rear Camera |
Clear the DTCs.
Recheck for DTCs and check that no DTCs are output.
If CAN communication system DTCs are stored, they may also be stored in other systems.
If the CAN communication system has been inspected and repaired in other systems, the DTCs will not be output when rechecking for DTCs.
If these DTCs are output frequently, duplicate the conditions that cause the problem symptoms and perform the inspection again, even though the DTC was not output when rechecking for DTCs.
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
| Result | Proceed to |
|---|---|
| DTCs are output | A |
| No DTCs are output | B |
A
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
B
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING