Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING SUPPORT BRAKE SYSTEM › from 2021.02
RM33C0E _56 Audio / Visual / Telematics _065452 PARK ASSIST / MONITORING _0387691 PARKING SUPPORT BRAKE SYSTEM W

PARK ASSIST / MONITORING  PARKING SUPPORT BRAKE SYSTEM  CUSTOMIZE PARAMETERS  


CUSTOMIZE PARKING SUPPORT BRAKE SYSTEM


a.

Customizing with the GTS.

NOTICE:
·

When the customer requests a change in a function, first make sure that the function can be customized.

·

Be sure to make a note of the current settings before customizing.

·

When troubleshooting a function, first make sure that the function is set to the default setting.



i.

Connect the GTS to the DLC3.


ii.

Turn the ignition switch to ON.


iii.

Turn the GTS on.


iv.

Enter the following menus: Body Electrical / Clearance Warning / Utility / Customize Setting.


v.

Select the setting by referring to the table below.

Clearance Warning
Tester Display Description Default Setting ECU
PKSB (O) Function Parking support brake (static objects) function setting ON $00:ON,$01:OFF Clearance warning ECU assembly
PKSB (O) Target Stopping Distance Stop distance status of parking support brake (static objects) function Far $00:Close,$01:Far Clearance warning ECU assembly
PKSB Switch State Stored Setting of the parking support brake system main switch status memory Stored $00:Stored,$01:Not Stored Clearance warning ECU assembly
PKSB (V) Function Parking support brake (rear crossing vehicles) function setting ON $00:ON,$01:OFF Clearance warning ECU assembly
50006 101