The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front lumbar power seat switch removal/installation are shown below.
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
Wear protective gloves. Sharp areas on the parts may injure your hands.
1.REMOVE FRONT SEAT ASSEMBLY RH
71073S
2.DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER
72494
3.REMOVE VERTICAL ADJUSTING HANDLE RH
72551B
4.REMOVE RECLINING HINGE COVER RH
72525A
5.REMOVE RECLINING ADJUSTER RELEASE HANDLE RH
71848A
6.REMOVE SEAT ADJUSTER COVER CAP RH
71811D
7.REMOVE FRONT SEAT CUSHION SHIELD RH
84922A
8.REMOVE FRONT LUMBAR POWER SEAT SWITCH
Remove the 2 screws and front lumbar power seat switch from the front seat cushion shield RH.