The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during roof antenna assembly removal/installation are shown below.
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
1.REMOVE ROOF HEADLINING ASSEMBLY
2.REMOVE ROOF ANTENNA ASSEMBLY WITH COVER (except Panoramic Moon Roof)
Disconnect the connector.
Remove the bolt.
|
Remove in this Direction |
Pull the washer and holder as shown in the illustration and remove the roof antenna assembly with cover.
86300J
3.REMOVE ROOF ANTENNA ASSEMBLY (except Panoramic Moon Roof)
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Pull the roof antenna assembly in the direction indicated by the arrow (1) shown in the illustration to disengage the 3 claws and 2 guides.
Pull the roof antenna assembly in the direction indicated by the arrow (2) shown in the illustration to disengage the guide and remove the roof antenna assembly.
86300J
4.REMOVE ROOF ANTENNA ASSEMBLY (for Panoramic Moon Roof)
Disconnect the connector.
Remove the nut and clip.
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Disengage the 2 claws and remove the roof antenna assembly as shown in the illustration.