Home › Power Source / Network › A25A-FXS (BATTERY / CHARGING) › BATTERY CURRENT SENSOR › from 2021.02
RM33C0E _57 Power Source / Network _065427 A25A-FXS BATTERY / CHARGING _0329953 BATTERY CURRENT SENSOR A

A25A-FXS BATTERY / CHARGING  BATTERY CURRENT SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during battery state sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Auxiliary battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane Tracing Assist System (Click here)
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic View Monitor System (Click here)

PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 64718C 2.REMOVE LUGGAGE TRIM SERVICE HOLE COVER

Hide 28850C 3.REMOVE BATTERY STATE SENSOR ASSEMBLY

a.
A446124

Remove the nut and disconnect the No.2 frame wire from the battery state sensor assembly.

NOTICE:

When disconnecting the engine wire, some systems need to be initialized after the engine wire is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION



b.
A446125

Loosen the nut and remove the battery state sensor assembly from the auxiliary battery.


c.
A446126

Disconnect the battery state sensor assembly connector.