The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during tilt and telescopic switch removal/installation are shown below.
1. CHANGE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM SETTINGS
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Click hereGeneral>MAINTENANCE>AUXILIARY BATTERY>REMOVAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
45024
3.REMOVE LOWER STEERING COLUMN COVER SUB-ASSEMBLY
89235A
4.REMOVE TILT AND TELESCOPIC SWITCH
| *1 | Spiral Cable Connector |
| *2 | Tilt and Telescopic Connector |
Disconnect the spiral cable connector from the spiral cable sub-assembly.
Disconnect the tilt and telescopic connector from the tilt and telescopic switch.
Disengage the claw and pull out the tilt and telescopic switch.