Home › Engine / Hybrid System › A25A-FXS (FUEL) › FUEL PUMP ECU › from 2021.02
RM33C0E _51 Engine / Hybrid System _065421 A25A-FXS FUEL _0319773 FUEL PUMP ECU A

A25A-FXS FUEL  FUEL PUMP ECU  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel pump control ECU removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Auxiliary battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane Tracing Assist System (Click here)
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)

CAUTION:
·

Wear protective gloves. Sharp areas on the parts may injure your hands.

·
B394719

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION

·
B422343

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

·

If an airbag deploys for any reason, it may cause a serious injury.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 64718C 2.REMOVE LUGGAGE TRIM SERVICE HOLE COVER

Hide 3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 71940A 4.REMOVE REAR SEAT HEADREST ASSEMBLY

·

for Fold Down Seat Type (w/ Removable Headrest):

Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for Fold Down Seat Type)>REMOVAL


Hide 73350C 5.DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY

Hide 6.REMOVE REAR SEAT CUSHION ASSEMBLY

Hide 72693 7.REMOVE REAR SEAT CUSHION LOCK HOOK

Hide 72996A 8.REMOVE REAR SEATBACK COVER (for Reclining Seat Type)

Hide 9.REMOVE REAR SEATBACK ASSEMBLY LH

Hide 62332A 10.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH

Hide 11.REMOVE REAR SIDE SEATBACK ASSEMBLY LH

Hide 62331A 12.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH

HINT:

Use the same procedure as for the LH side.


Hide 13.REMOVE REAR SIDE SEATBACK ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.


Hide 81006 14.REMOVE CENTER STOP LIGHT SET

Hide 73370E 15.DISCONNECT REAR SEAT OUTER BELT ASSEMBLY LH

Hide 73360D 16.DISCONNECT REAR SEAT OUTER BELT ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.


Hide 62472A 17.REMOVE INNER ROOF SIDE GARNISH LH

Hide 62471A 18.REMOVE INNER ROOF SIDE GARNISH RH

HINT:

Use the same procedure as for the LH side.


Hide 73373F 19.REMOVE REAR SEAT SHOULDER BELT HOLE COVER

Hide 64330 20.REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (w/o Rear Sunshade)

Hide 64330 21.REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Rear Sunshade)

Hide 64272B 22.REMOVE ROOM PARTITION BOARD LH

Hide 89571 23.REMOVE FUEL PUMP CONTROL ECU

a.
A405258

Disconnect the 2 fuel pump control ECU connectors.


b.
A405259

Remove the nut and fuel pump control ECU from the vehicle body.

NOTICE:

Do not reuse the fuel pump control ECU if it has been dropped or subjected to a severe impact.



Hide 89573 24.REMOVE FUEL PUMP CONTROL ECU BRACKET

a.
A401809

Remove the 2 bolts and fuel pump control ECU bracket from the fuel pump control ECU.