Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENTRY AND START SYSTEM (for Start Function) › from 2021.02
RM33C0E _58 Vehicle Interior _065456 THEFT DETERRENT / KEYLESS ENTRY _0389661 ENTRY AND START SYSTEM(for Start Function) L

THEFT DETERRENT / KEYLESS ENTRY  ENTRY AND START SYSTEM(for Start Function)  PRECAUTION  


CAUTION REGARDING INTERFERENCE WITH ELECTRONIC DEVICES


CAUTION:

As weak radio waves are emitted from the electrical key transmitter sub-assembly, if a pacemaker is being used, be sure to read the pacemaker instruction manual and the following.

·

People with implantable cardiac pacemakers, cardiac resynchronization therapy-pacemakers or implantable cardioverter defibrillators should keep away from the entry and start system antennas. The radio waves may affect the operation of such devices. If necessary, the entry function can be disabled. Ask your dealer for details, such as the frequency of radio waves and timing of the emitted radio waves. Then, consult your doctor to see if you should disable the start function.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENTRY AND START SYSTEM (for Start Function)>CUSTOMIZE PARAMETERS

·

User of any electrical medical device other than implantable cardiac pacemakers, cardiac resynchronization therapy-pacemakers or implantable cardioverter defibrillators should consult the manufacturer of the device for information about its operation under the influence of radio waves. Radio waves could have unexpected effects on the operation of such medical devices.

·

Ask your dealer for details for disabling the entry and start system.

Exterior antenna
·

Front door outside handle assembly (for Driver Door)

·

Front door outside handle assembly (for Front Passenger Door)

·

Electrical key antenna (outside luggage compartment)


Interior antenna
·

No. 1 indoor electrical key antenna assembly (front floor)

·

No. 1 indoor electrical key antenna assembly (rear floor)

·

No. 1 indoor electrical key antenna assembly (inside luggage compartment)





HINT:

The entry and start system can be disabled by a customize setting.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENTRY AND START SYSTEM (for Start Function)>CUSTOMIZE PARAMETERS



PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL


NOTICE:

When disconnecting the cable from the negative (-) auxiliary battery terminal, initialize the following systems after the cable is reconnected.

System Name See Procedure
Lane Tracing Assist System (Click here)
Pre-collision System
Parking Assist Monitor System
Panoramic View Monitor System



PRECAUTION WHEN USING GTS


a.

When the power switch is turned off, the DTCs stored in the steering lock ECU (steering lock actuator or upper bracket assembly) will be cleared. Be sure to record any output DTCs immediately.


b.

When using the GTS with the power switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry&Start(CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.



PRECAUTION FOR REGISTRATION


a.

If replacing any of the following parts, refer to Service Bulletin.

i.

Certification ECU (smart key ECU assembly)


ii.

Steering lock ECU (steering lock actuator or upper bracket assembly)


iii.

ID code box (immobiliser code ECU)*

*: w/ ID Code Box



iv.

Hybrid vehicle control ECU assembly


v.

Electrical key transmitter sub-assembly


vi.

Main body ECU (multiplex network body ECU)




PRECAUTIONS FOR STEERING LOCK / UNLOCK FUNCTION


a.

After turning the power switch off and opening and closing any of the doors, the steering wheel will be locked due to the steering lock function. Operating the power switch again automatically cancels the steering lock function.


b.

To prevent the steering lock motor from overheating, the motor operation may be suspended if the steering is locked and unlocked repeatedly in a short period of time. In this case, refrain from operating the power switch. After about 10 seconds, the steering lock motor will resume functioning.