Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT PASSENGER AIRBAG ASSEMBLY › from 2021.02
RM33C0E _58 Vehicle Interior _065460 SUPPLEMENTAL RESTRAINT SYSTEMS _0331863 FRONT PASSENGER AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT PASSENGER AIRBAG ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during instrument panel passenger airbag assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Perform steering sensor zero point calibration Lane tracing assist system (Click here)
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (Click here)

PROCEDURE

Hide 1. PRECAUTION

CAUTION:
B394719

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 55650 2.REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 82149A 3.DISCONNECT NO. 5 INSTRUMENT PANEL WIRE (w/o Occupant Classification System)

a.

Check that the power switch is off.


b.

Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:
B422343

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



c.
B468703C01
0.979,3.073 0.979,2.781 true 0.917,3.094 1.125,3.26 0.208,0.167 10 false *a
*a Slider
V113147

Release in this Direction


Slide the slider to release the lock, and then disconnect the connector.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.



Hide 82149A 4.DISCONNECT NO. 5 INSTRUMENT PANEL WIRE (w/ Occupant Classification System)

a.

Check that the power switch is off.


b.

Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:
B422343

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



c.
B468718C01
0.667,3.01 0.844,2.74 0.844,2.74 1.031,2.74 true 1.063,2.656 1.375,2.813 0.313,0.156 10 false *a
*a Slider
V113147

Release in this Direction


Slide the slider to release the lock, and then disconnect the connector.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.



Hide 5.REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

Hide 73960A 6.REMOVE INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY (w/o Occupant Classification System)

CAUTION:
B417757C02
0.917,0.938 1.063,1.125 0.146,0.188 10 false .
V100155

Deployment Side


When storing the instrument panel passenger airbag assembly, keep the airbag deployment side facing upward.


a.
B468697

Remove the 2 screws and disengage the clamp.


b.
B468698C01
2.146,1.354 2.469,1.927 2.469,1.927 2.729,1.927 true 2.781,1.844 2.99,2.042 0.208,0.198 10 true *a
*a Passenger Airbag Door Retainer
V113147

Move the screwdriver in this Direction


Using a screwdriver, pry back the passenger airbag door retainer to disengage the 3 hooks as shown in the illustration.

NOTICE:

Do not damage the deployment surface of the instrument panel passenger airbag assembly.



c.
B468699

Disengage the 3 hooks to remove the instrument panel passenger airbag assembly from the instrument panel safety pad sub-assembly.


Hide 73960A 7.REMOVE INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY (w/ Occupant Classification System)

CAUTION:
B417757C02
0.917,0.938 1.063,1.125 0.146,0.188 10 false .
V100155

Deployment Side


When storing the instrument panel passenger airbag assembly, keep the airbag deployment side facing upward.


a.
B490008

Remove the 2 screws and disengage the clamp.


b.
B468721C01
2.156,1.354 2.531,1.823 2.531,1.823 2.813,1.823 true 2.833,1.74 3.042,1.948 0.208,0.208 10 true *a
*a Passenger Airbag Door Retainer
V113147

Move the screwdriver in this Direction


Using a screwdriver, pry back the passenger airbag door retainer to disengage the 3 hooks as shown in the illustration.

NOTICE:

Do not damage the deployment surface of the instrument panel passenger airbag assembly.



c.
B468723

Disengage the 3 hooks to remove the instrument panel passenger airbag assembly from the instrument panel safety pad sub-assembly.


Hide 82149A 8.REMOVE NO. 5 INSTRUMENT PANEL WIRE (w/o Occupant Classification System)

a.
B468705C01
0.833,0.583 1.375,0.583 1.375,0.583 1.604,0.75 true 0.927,2.594 0.823,2.813 0.823,2.813 0.479,2.813 true 0.542,0.865 1.542,0.865 true 0.656,0.5 0.844,0.667 0.188,0.167 10 false *a 0.354,0.792 0.542,0.969 0.188,0.177 10 true *b 0.302,2.74 0.51,2.938 0.208,0.198 10 false *c
*a Protective Tape
*b Airbag Connector
*c Airbag Connector Locking Button
V113147

Release in this Direction


Using a screwdriver with its tip wrapped with protective tape, release the airbag connector locking button.


b.

Disconnect the airbag connector to remove the No. 5 instrument panel wire from the instrument panel passenger airbag assembly.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.



Hide 82149A 9.REMOVE NO. 5 INSTRUMENT PANEL WIRE (w/ Occupant Classification System)

a.
B468724C01
1.365,0.813 0.583,0.813 true 2.583,0.844 1.802,0.844 true 1.469,0.688 1.188,0.385 1.188,0.385 0.906,0.385 true 1.344,2.896 1.052,2.896 1.052,2.896 0.781,2.594 true 0.74,0.292 0.938,0.51 0.198,0.219 10 false *a 0.417,0.729 0.625,0.948 0.208,0.219 10 false *b 1.365,2.802 1.594,3.031 0.229,0.229 10 false *c 2.615,0.75 2.823,0.969 0.208,0.219 10 false *b
*a Protective Tape
*b Airbag Connector
*c Airbag Connector Locking Button
V113147

Release in this Direction


Using a screwdriver with its tip wrapped with protective tape, release the 2 airbag connector locking buttons.


b.

Disconnect the 2 airbag connectors to remove the No. 5 instrument panel wire from the instrument panel passenger airbag assembly.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.