Home › Audio / Visual / Telematics › AUDIO / VIDEO › DIGITAL AUDIO BROADCASTING ANTENNA › from 2021.02
RM33C0E _56 Audio / Visual / Telematics _065450 AUDIO / VIDEO _0333636 DIGITAL AUDIO BROADCASTING ANTENNA A

AUDIO / VIDEO  DIGITAL AUDIO BROADCASTING ANTENNA  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during digital audio broadcasting antenna assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Disconnect cable from negative auxiliary battery terminal Perform steering sensor zero point calibration Lane Tracing Assist System (Click here)
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)

CAUTION:
B401522

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


PROCEDURE

Hide 1.REMOVE ROOF HEADLINING ASSEMBLY

Hide 863C0 2.REMOVE DIGITAL AUDIO BROADCASTING ANTENNA ASSEMBLY

NOTICE:

Do not touch the contact points.


a.
E372258

Disconnect the connector.


b.

Remove the nut.


c.

Disengage the guide to remove the digital audio broadcasting antenna assembly.