CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) AND INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY (w/ Automatic Retractable Mirror)
| *A | for LHD | *B | for RHD |
Remove the main body ECU (multiplex network body ECU) from the instrument panel junction block assembly.
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL
Reconnect the instrument panel junction block assembly connectors.
Measure the resistance and voltage according to the value(s) in the table below.
Measure the values on the wire harness side with the connector disconnected.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| MB-11 (GND1) - Body ground | - | Ground | Always | Below 1 Ω |
| MB-31 (BECU) - Body ground | - | Auxiliary battery power supply | Power switch off | 11 to 14 V |
| MB-30 (ACC) - Body ground | - | Ignition power supply (ACC signal) | Power switch on (ACC) | 11 to 14 V |
| MB-30 (ACC) - Body ground | - | Ignition power supply (ACC signal) | Power switch off | Below 1 V |
| MB-32 (IG) - Body ground | - | Ignition power supply (IG signal) | Power switch on (IG) | 11 to 14 V |
| MB-32 (IG) - Body ground | - | Ignition power supply (IG signal) | Power switch off | Below 1 V |
Install the main body ECU (multiplex network body ECU) to instrument panel junction block assembly.
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>INSTALLATION
Measure the voltage according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| K53-16 (RET) - Body ground | B -Body ground | Power retract mirror motor drive voltage | Retractable outer mirror switch on outer mirror switch assembly in retracted position. | Below 1 V |
| Retractable outer mirror switch on outer mirror switch assembly not in retracted position. | 11 to 14 V | |||
| K53-6 (AMR) - Body ground | BE - Body ground | Power retract mirror motor drive voltage | Retractable outer mirror switch on outer mirror switch assembly in auto position. | Below 1 V |
| Retractable outer mirror switch on outer mirror switch assembly not in auto position. | 11 to 14 V | |||
| K52-10 (RETR) - Body ground | B -Body ground | Power retract mirror motor drive voltage | Outer rear view mirror assembly moving to retracted position. | Below 1 V |
| Outer rear view mirror assembly not moving. | 11 to 14 V | |||
| K52-11 (RTRR) - Body ground | LG - Body ground | Power retract mirror motor drive voltage | Outer rear view mirror assembly moving to driving position. | Below 1 V |
| Outer rear view mirror assembly not moving. | 11 to 14 V |
CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY
Click hereVehicle Exterior>WINDOW / GLASS>WINDOW DEFOGGER SYSTEM>TERMINALS OF ECU
CHECK AIR CONDITIONING CONTROL ASSEMBLY
Click hereVehicle Exterior>WINDOW / GLASS>WINDOW DEFOGGER SYSTEM>TERMINALS OF ECU