INITIALIZATION
Make sure to perform the necessary procedures (adjustment, calibration, initialization, or registration) after parts related to the charging system have been removed/installed or replaced.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
CHARGING SYSTEM PRECAUTION
Orange wire harnesses and connectors indicate high-voltage circuits. To prevent electric shock, always follow the procedure described in the repair manual.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
To prevent electric shock, wear insulated gloves when working on wire harnesses and components of the high voltage system.
If the auxiliary battery is fully depleted or the READY indicator does not illuminate, recharge the auxiliary battery.
Never disconnect the auxiliary battery while the power switch is on (READY).
Before giving the auxiliary battery a quick charge, disconnect the auxiliary battery cables.
Check the auxiliary battery again before the vehicle is returned to the customer.
When replacing the auxiliary battery with a new one, use an auxiliary battery with the same physical dimensions, a collective ventilation system and a 20-hour rate (20 AHr) capacity of 55 Ah or more.