Home › Vehicle Interior › INTERIOR PANELS / TRIM › REAR SUNSHADE ASSEMBLY › from 2021.02
RM33C0E _58 Vehicle Interior _065466 INTERIOR PANELS / TRIM _0328289 REAR SUNSHADE ASSEMBLY A

INTERIOR PANELS / TRIM  REAR SUNSHADE ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear sun shade removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative (-) auxiliary battery terminal Perform steering sensor zero point calibration Lane Tracing Assist System (Click here)
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)

CAUTION:
B401522

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


PROCEDURE

Hide 1.REMOVE REAR SEAT ASSEMBLY (for Fold Down Seat Type)

Hide 2.REMOVE REAR SEAT ASSEMBLY (for Reclining Seat Type)

Hide 81006 3.REMOVE CENTER STOP LIGHT SET

Hide 73370E 4.DISCONNECT REAR SEAT OUTER BELT ASSEMBLY LH

Hide 73360D 5.DISCONNECT REAR SEAT OUTER BELT ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.


Hide 62472A 6.REMOVE INNER ROOF SIDE GARNISH LH

Hide 62471A 7.REMOVE INNER ROOF SIDE GARNISH RH

HINT:

Use the same procedure as for the LH side.


Hide 73373F 8.REMOVE REAR SEAT SHOULDER BELT HOLE COVER

Hide 64330 9.REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY

Hide 64272B 10.REMOVE ROOM PARTITION BOARD LH (for Fold Down Seat Type)

Hide 64271G 11.REMOVE ROOM PARTITION BOARD RH (for Fold Down Seat Type)

Hide 64165B 12.REMOVE NO. 1 UPPER BACK PANEL HOLE COVER

a.

Remove the No. 1 upper back panel hole cover.


Hide 64340B 13.REMOVE NO. 2 PACKAGE TRAY TRIM PANEL ASSEMBLY

a.
B481837C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the 3 clips as shown in the illustration.


b.
B481838C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the 5 guides to remove the No. 2 package tray trim panel assembly as shown in the illustration.


Hide 64350A 14.REMOVE REAR WINDOW SHADE ASSEMBLY

a.
B481839N01
2.5,0.052 2.656,0.25 0.156,0.198 10 true A 0.146,0.875 0.302,1.073 0.156,0.198 10 true A 0.125,1.25 0.281,1.448 0.156,0.198 10 true A 2.99,1.542 3.146,1.74 0.156,0.198 10 true B

Disconnect the connector.


b.

Remove the 3 bolts (A).


c.

Loosen the bolt (B) and remove the rear window shade assembly.

NOTICE:

Bolt (B) cannot be removed from the rear window shade assembly.