3S-FE Engine
Repair Manual · 3S-FEエンジン
- Whole chapterOriginal From 1990.8 From 1991.8 From 1992.8
Engine Tune-up
- PreparationOriginalFrom 1991.8
- Basic InspectionOriginalFrom 1990.8
- V-belt Tension and Deflection Adjustment
- Valve Clearance Inspection and Adjustment
- CO/HC Concentration CheckOriginalFrom 1991.8
- P/S Idle-up Inspection
- Outline of Changes · From 1990.8
Emission Control System
- PreparationOriginalFrom 1990.8From 1991.8
Air-fuel Ratio Compensation
Spark Timing Control
Deceleration Control
- On-vehicle InspectionOriginalFrom 1990.8
- Throttle Position Sensor Inspection
Component Inspection
- Throttle Position Sensor Inspection
- VSV (Canister Purge) · From 1991.8
- Check Valve (Canister Purge) · From 1991.8
EFI System
- PreparationOriginalFrom 1990.8From 1991.8
Troubleshooting
Fuel System
- Preventing Fuel SpillsOriginalFrom 1990.8
- Fuel Leak CheckOriginalFrom 1990.8
On-vehicle Inspection
Pressure Regulator
Injectors
- Components for Removal and InstallationOriginalFrom 1990.8
- RemovalOriginalFrom 1990.8
- Inspection
- InstallationOriginalFrom 1990.8
- Fuel Filter
- Fuel Tank and Fuel Pump
- Control SystemOriginalFrom 1990.8
- Component LocationsOriginalFrom 1990.8
Throttle Body
- Components for Removal and Installation
- Removal
- Inspection
- Disassembly
- Reassembly
- Installation
- Inspection and Adjustment
Component Inspection
Throttle Position Sensor
ISC Valve
Water Temperature Sensor
EFI Main Relay
Intake Air Temperature Sensor
Circuit Opening Relay
Engine Control Computer
- InspectionOriginalFrom 1990.8
Inspection by Diagnosis
Troubleshooting (Diagnosis)
- How to Troubleshoot · From 1991.8
- Diagnosis Check (Normal Mode) · From 1991.8
- Diagnosis Check (Test Mode) · From 1991.8
Engine Assembly
- PreparationOriginalFrom 1990.8
Engine Removal and Installation
- Torque Specifications
- Removal and Installation NotesOriginalFrom 1990.8
Partial Engine Assembly
Engine Mechanical
- PreparationOriginalFrom 1990.8
Timing Belt
Camshaft Oil Seal
Camshaft No.1
Camshaft No.2
Cylinder Head Gasket
- Components for Removal and InstallationOriginalFrom 1990.8
- Removal
- Installation
Crankshaft Front Oil Seal
Engine Rear Oil Seal
Ignition
Component Inspection
- DistributorFrom 1990.8From 1992.8
- IgniterFrom 1990.8From 1992.8
- High-tension Cords · From 1992.8
- Spark Plugs · From 1992.8
- Ignition Coil · From 1992.8
- Charging
- 3S-FE Engine Changes
- Outline of ChangesFrom 1990.8From 1991.8From 1992.8
S-FE Engine Changes
Cylinder Head
Cylinder Block
- Disassembly · From 1990.8
- Piston and Connecting Rod Disassembly · From 1990.8
- Piston and Connecting Rod Inspection · From 1990.8
- Crankshaft Inspection · From 1990.8
- Piston and Connecting Rod Reassembly · From 1990.8
- Cylinder Block Reassembly · From 1990.8