Home › General › INTRODUCTION › WORK NOTICES AND PRECAUTIONS
BM2850E _V1 General _075896 INTRODUCTION _0369094 WORK NOTICES AND PRECAUTIONS F

INTRODUCTION  WORK NOTICES AND PRECAUTIONS  PRECAUTIONS FOR WELDING  


REMOVAL OF ADJACENT COMPONENTS


a.
K110072

To prevent damage to the body and parts, apply protective tape to the body and tools before removing the parts.

NOTICE:

If the paint film is damaged, make sure to refinish the paint.




CUTTING WORK


K110073

a.

When cutting a panel, be careful not to damage the surrounding panels or any panels underneath.

NOTICE:

If any panels are damaged, be sure to repair them.




ANTI-RUST TREATMENT BEFORE WELDING


a.
K110074

Apply welding primer to the contact surfaces of the welding areas to protect them from rust.

NOTICE:

Do not apply welding primer outside of the contact surfaces.




WELDING WORK


a.

Standard Number of Welds

Number of spot welds More than 1.3x the number of welds made by the manufacturer
Number of plug welds More than the number of welds made by the manufacturer


b.
K110077C01
1.469,0.208 2.135,0.208 2.135,0.208 2.135,1.021 false 1.792,1.042 1.792,0.219 false 2.906,1.781 2.417,1.781 2.417,1.781 2.417,0.958 false 2.677,1.781 2.677,0.896 false 1.323,0.156 1.635,0.354 0.313,0.198 10 false *a 2.948,1.719 3.26,1.917 0.313,0.198 10 false *b
*a Old Spot Locations
*b New Spot Locations


Spot weld locations

Avoid welding over previously welded areas.



MAKING HOLES FOR PLUG WELDING


K110078C02
1.396,1.896 1.573,1.896 1.573,1.896 2.021,1.625 false 1.146,1.802 1.458,2.104 0.313,0.302 10 false *a
*a Puncher


a.

For areas where a spot welder cannot be used, use a puncher or drill to make holes for plug welding.

Thickness of Welded Portion Diameter of Plug Hole
Under 1.0 mm (0.04 in.) Over 5.0 mm (0.20 in.)
1.0 to 1.6 mm (0.04 to 0.06 in.) Over 6.5 mm (0.26 in.)
1.7 to 2.3 mm (0.07 to 0.09 in.) Over 8.0 mm (0.31 in.)
Over 2.4 mm (0.09 in.) Over 10 mm (0.39 in.)