REMOVAL
| Symbol Meaning | |
|---|---|
|
Remove Weld Points |
|
Cut and Join Location |
*a in illustration above indicates where the adhesive is located.
Roughly cut open the panel so that the adhesive can be reached. Cut through the adhesive with a cut chisel to remove the panel.
In cases where the adhesive cannot be removed with a cut chisel, heat the adhesive with an industrial heater gun or gas burner taking care not to cause panel deformation by overheating.
| *A | for LPG | - | - |
| *b | mm (in.) | - | - |
INSTALLATION
| Symbol Meaning | |
|---|---|
|
Plug Weld |
|
Cut and Join Location |
|
Fillet Weld |
|
Butt Weld |
|
Body Sealer |
Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.
*a Dent one part about 1 to 2 mm (0.04 to 0.08 in.) .
Before temporarily installing the new parts, weld the front side panel outer and mudguard bracket front with the standard number of welding points.
Before temporarily installing the new parts, weld the front side panel outer, mudguard bracket front and front body pillar lower hinge retainer with the standard number of welding points. (for LPG)
Before installing a new part, apply body sealer.
Apply body sealer evenly about 5 mm (0.20 in.) from the flange, avoiding any oozing.
Apply body sealer evenly, about 3 to 4 mm (0.12 to 0.16 in.) in diameter.
Apply adhesive (3MTM AutomixTM Panel Bonding Adhesive #8115) to the area indicated by *b in the illustration.
Apply a light coat of adhesive around the plug welding points.
Apply enough adhesive to the panels.
After welding, apply body sealer to the corresponding parts. (See the painting / coating)
After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.
| *c | mm (in.) | - | - |
| *1 | FRONT SIDE PANEL OUTER | *2 | MUDGUARD BRACKET FRONT |
| *3 | FRONT BODY PILLAR LOWER HINGE RETAINER | - | - |
| *A | for LPG | - | - |
| *A | for LPG | - | - |
| *c | mm (in.) | - | - |
| *1 | Plug Weld | *2 | Reference Surface |
| *3 | New Panel | *4 | Fillet Weld |
| *5 | Putty | *6 | Vehicle Side Panel |
| *7 | Cross Section Illustration | - | - |
| *c | mm (in.) | - | - |