REMOVAL
| Symbol Meaning | |
|---|---|
|
Remove Weld Points |
|
Cut with Disc Sander etc. |
|
Cut and Join Location |
|
Cut Location for Supply Parts |
*a in illustration above indicates where the adhesive is located.
Roughly cut open the panel so that the adhesive can be reached. Cut through the adhesive with a cut chisel to remove the panel.
In cases where the adhesive cannot be removed with a cut chisel, heat the adhesive with an industrial heater gun or gas burner taking care not to cause panel deformation by overheating.
| *A | for Standard Body | - | - |
| *b | mm (in.) | - | - |
| *A | for Long Body | - | - |
| *b | mm (in.) | - | - |
INSTALLATION
| Symbol Meaning | |
|---|---|
|
Plug Weld |
|
Cut and Join Location |
|
Fillet Weld |
|
Butt Weld |
|
Body Sealer |
Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.
*a Dent one part about 1 to 2 mm (0.04 to 0.08 in.).
Before installing a new part, apply body sealer.
Apply body sealer evenly about 5 mm (0.20 in.) from the flange, avoiding any oozing.
Apply body sealer evenly, about 3 to 4 mm (0.12 to 0.16 in.) in diameter.
Apply adhesive (3MTM AutomixTM Panel Bonding Adhesive #8115) to the area indicated by *b in the illustration.
Apply a light coat of adhesive around the plug welding points.
Apply enough adhesive to the panels.
After welding, apply body sealer to the corresponding parts. (See the painting / coating)
After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.
| *A | for Standard Body | - | - |
| *c | mm (in.) | - | - |
| *A | for Standard Body | - | - |
| *1 | REAR BODY PANEL FRONT | - | - |
| *c | mm (in.) | - | - |
| *A | for Standard Body | - | - |
| *A | for Standard Body | - | - |
| *1 | Plug Weld | *2 | Reference Surface |
| *3 | New Panel | *4 | Fillet Weld |
| *5 | Putty | *6 | Vehicle Side Panel |
| *7 | Cross Section Illustration | - | - |
| *c | mm (in.) | - | - |
| *A | for Long Body | - | - |
| *c | mm (in.) | - | - |
| *A | for Long Body | - | - |
| *1 | REAR BODY PANEL FRONT | - | - |
| *c | mm (in.) | - | - |
| *A | for Long Body | - | - |
| *A | for Long Body | - | - |
| *1 | Plug Weld | *2 | Reference Surface |
| *3 | New Panel | *4 | Fillet Weld |
| *5 | Putty | *6 | Vehicle Side Panel |
| *7 | Cross Section Illustration | - | - |
| *c | mm (in.) | - | - |