With the side panel No.4 RH removed.
REMOVAL
| Symbol Meaning | |
|---|---|
|
Remove Weld Points |
|
Cut Location for Supply Parts |
*a in illustration above indicates where the adhesive is located.
Roughly cut open the panel so that the adhesive can be reached. Cut through the adhesive with a cut chisel to remove the panel.
In cases where the adhesive cannot be removed with a cut chisel, heat the adhesive with an industrial heater gun or gas burner taking care not to cause panel deformation by overheating.
| *A | for Standard Body | - | - |
| *A | for Long Body | - | - |
INSTALLATION
| Symbol Meaning | |
|---|---|
|
Plug Weld |
|
Butt Weld |
|
Body Sealer |
Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.
Before temporarily installing the new parts, weld the rear body panel rear, side panel to rear mudguard bracket and mudguard bracket rear with the standard number of welding points.
Before installing a new part, apply body sealer.
Apply body sealer evenly about 5 mm (0.20 in.) from the flange, avoiding any oozing.
Apply body sealer evenly, about 3 to 4 mm (0.12 to 0.16 in.) in diameter.
Apply adhesive (3MTM AutomixTM Panel Bonding Adhesive #8115) to the area indicated by *a in the illustration.
Apply a light coat of adhesive around the plug welding points.
Apply enough adhesive to the panels.
After welding, apply body sealer to the corresponding parts. (See the painting / coating)
After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.
| *1 | REAR BODY PANEL REAR | *2 | SIDE PANEL TO REAR MUDGUARD BRACKET |
| *3 | MUDGUARD BRACKET REAR | - | - |
| *A | for Standard Body | - | - |
| *b | mm (in.) | - | - |
| *A | for Long Body | - | - |
| *b | mm (in.) | - | - |