With the roof panel No.4 and roof panel No.6 removed.
w/ ROOF SIDE REINFORCEMENT (See the 2019/08-)
REMOVAL
| Symbol Meaning | |
|---|---|
|
Remove Weld Points |
| *A | for Glide Type | *B | LH |
| *A | for Folding Type | *B | LH |
| *A | RH | - | - |
INSTALLATION
| Symbol Meaning | |
|---|---|
|
Plug Weld |
Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.
Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)
Before temporarily installing the new parts, weld the roof side panel outer and roof drip side channel center No.1 with the standard number of welding points.
After welding, apply body sealer to the corresponding parts. (See the painting / coating)
After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.
| *1 | ROOF SIDE PANEL OUTER | *2 | ROOF DRIP SIDE CHANNEL CENTER NO.1 |
| *A | for Glide Type | *B | LH |
| *A | for Folding Type | *B | LH |
| *A | RH | - | - |
| *1 | ROOF SIDE PANEL OUTER | - | - |