Heat the double-sided tape remaining on the body with an infrared lamp or equivalent.
Heat the tape to 40 to 60°C for approximately 1 to 2 minutes.
Wipe off the remaining double-sided tape using a clean cloth or equivalent.
If a name plate is installed without thoroughly removing the remaining double-sided tape fromthe body, the name plate will not adhere properly. Make sure to thoroughly wipe off thedoublesided tape.
After cleaning the installation area of the body with degreasing agent, attach the name plate to theposition shown in the illustration.
The working environment should be 20°C when installing the name plate. If the working environment isbelow 20°C, heat the installation area of the body to 20 to 30°C and then install the name plate.
NO. 1 BACK DOOR EMBLEM (for Double Swing Out Type)
| *a | Boss |
NO. 1 BACK DOOR EMBLEM (for Luggage Compartment)
| *a | 257 mm (10.118 in.) |
| *b | 69.3 mm (2.728 in.) |
| *c | Vehicle Center |
| *d | Edge of Curved Surface |
NO. 1 REAR BODY NAME PLATE (for Double Swing Out Type)
| *a | 257 mm (10.118 in.) |
| *b | 13.7 mm (0.539 in.) |
| *c | No. 1 Back Door Emblem Center |
| *d | Edge of Curved Surface |
NO. 2 REAR BODY NAME PLATE (for Luggage Compartment)
| *a | 257 mm (10.118 in.) |
| *b | 12.3 mm (0.484 in.) |
| *c | Vehicle Center |
| *d | Edge of Curved Surface |
NO. 2 REAR BODY NAME PLATE (for Double Swing Out Type)
| *a | 257 mm (10.118 in.) |
| *b | 13.7 mm (0.539 in.) |
| *c | No. 2 Back Door Emblem Center |
| *d | Edge of Curved Surface |