REMOVAL
| Symbol Meaning | |
|---|---|
|
Remove Weld Points |
*a in illustration above indicates where the adhesive is located.
Roughly cut open the panel so that the adhesive can be reached. Cut through the adhesive with a cutchisel to remove the panel.
In cases where the adhesive cannot be removed with a cut chisel, heat the adhesive with an industrialheater gun or gas burner taking care not to cause panel deformation by overheating.
INSTALLATION
| Symbol Meaning | |
|---|---|
|
Plug Weld |
Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.
Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)
Apply adhesive (3MTM AutomixTM Panel Bonding Adhesive #8115) to the area indicated by *a in the illustration.
Apply a light coat of adhesive around the plug welding points.
Apply enough adhesive to the panels.
After welding, apply body sealer to the corresponding parts. (See the painting / coating)
After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.
| *1 | FRONT PANEL SUB-ASSEMBLY | - | - |