With the front side panel outer RH removed.
REMOVAL
| Symbol Meaning | |
|---|---|
|
Remove Weld Points |
|
Cut Location for Supply Parts |
| *A | for Driver side | - | - |
| *A | for Driver side | - | - |
INSTALLATION
| Symbol Meaning | |
|---|---|
|
Plug Weld |
|
Butt Weld |
|
Body Sealer |
Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.
Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)
Before temporarily installing the new parts, weld the front body pillar lower outer and front body pillar sub-assembly outer with the standard number of welding points.
Apply adhesive (3MTM AutomixTM Panel Bonding Adhesive #8115) to the area indicated by *b in the illustration.
Apply a light coat of adhesive around the plug welding points.
Apply enough adhesive to the panels.
Before installing a new part, apply body sealer.
Apply body sealer in an even, continuous bead.
After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.
| *A | for Driver side | *B | except Super Long Body |
| *C | for Super Long Body | - | - |
| *1 | FRONT BODY PILLAR LOWER OUTER | *2 | FRONT BODY PILLAR SUB-ASSEMBLY OUTER |
| *A | for Driver side | - | - |