Home › Power Source / Network › NETWORKING › CAN COMMUNICATION SYSTEM › 2017.01–2019.08
NM2850E _57 Power Source / Network _074169 NETWORKING _0361176 CAN COMMUNICATION SYSTEM GE GENERAL F

NETWORKING  CAN COMMUNICATION SYSTEM  GENERAL  GENERAL  


OUTLINE


a.

The Controller Area Network (CAN) has been adopted for the some models.


b.

The Controller Area Network (CAN) is a serial data communication network for real-time application. It is a multiplex communication network to be equipped in a vehicle, and has communication speeds of 500 kbps (HS-CAN) and the ability to detect malfunctions.


c.

HS-CAN consists of a bus 2, bus 4, bus 5 and V bus.


d.

The communication wire used is a twisted-pair wire. The bus line has a high line (2.5 V to 3.5 V is applied) and a low line (1.5 V to 2.5 V is applied).


e.

The central gateway ECU (network gateway ECU) has a gateway function and is used to transmit data between bus 2, bus 4, bus 5 and V bus.


f.

The terminating resistors for each bus are located as shown in the following table.

Bus Terminating Resistor Location Gateway Function Gateway Destination

*1: Models with SRS airbag system

*2: Models without SRS airbag system

CAN Bus 2
·

Central Gateway ECU (Network Gateway ECU)

·

ECM


Central Gateway ECU (Network Gateway ECU) to Each Bus
CAN Bus 4
·

Central Gateway ECU (Network Gateway ECU)

·

Air Bag ECU Assembly*1

·

CAN Junction Terminal*2


Central Gateway ECU (Network Gateway ECU) to Each Bus
CAN Bus 5
·

Central Gateway ECU (Network Gateway ECU)

·

Combination Meter Assembly


Central Gateway ECU (Network Gateway ECU) to Each Bus
CAN V Bus Central Gateway ECU (Network Gateway ECU) Central Gateway ECU (Network Gateway ECU) to Each Bus