Home › Engine / Hybrid System › 1BZ-FPE (ENGINE CONTROL) › ELECTRONIC CONTROLLED CARBURETOR SYSTEM › 2017.01–2021.01
NM2850E _51 Engine / Hybrid System _074200 1BZ-FPE ENGINE CONTROL _0361445 ELECTRONIC CONTROLLED CARBURETOR SYSTEM CO CONTROL F

1BZ-FPE ENGINE CONTROL  ELECTRONIC CONTROLLED CARBURETOR SYSTEM  CONTROL  IDLE SPEED CONTROL  


FUNCTION


a.

In this system, the engine ECU calculates the target engine speed in accordance with the engine condition, and determined the bypass air volume, thus controlling the idle speed.

W115501E02
3.979,0.729 4.313,0.396 4.313,0.396 4.438,0.396 false 0.385,0.385 2.292,0.583 1.906,0.198 10 false Distributor (Crankshaft Angle) 0.521,0.854 2.104,1.083 1.583,0.229 10 false Throttle Position Sensor 0.448,1.302 2.229,1.531 1.781,0.229 10 false Water Temperature Sensor 0.854,1.771 1.802,1.979 0.948,0.208 10 false Starter Signal 0.906,2.229 1.74,2.438 0.833,0.208 10 false A/C Switch 0.385,2.792 2.167,3.125 1.781,0.333 10 false Power Steering Oil Pressure Switch 0.646,3.365 2.063,3.604 1.417,0.24 10 false Vehicle Speed Signal 4.51,0.313 5.406,0.625 0.896,0.313 10 false Engine ECU 5.958,1.885 6.573,2.104 0.615,0.219 10 false ISCV

i.

Function of Engine ECU

1.

Feedback Control

During idling, the feedback control controls the bypass air volume to achieve the target idle speed, if there is a difference between the target idle speed calculated by the engine ECU and the actual idle speed.


2.

Warm-up Control

Controls the bypass air volume during warm-up to achieve and optimal fast idle speed in accordance with water temperature.


3.

Engine Speed Change Estimate Control

Immediately after the air conditioner switch is engaged, the idle speed can be affected by the change in the load that is applied to the engine. To prevent this symptom, the engine speed change estimate control increases or decreases the bypass air volume before the idle speed changes.