SYSTEM CONTROL
When the vehicle starts off on a steep or slippery hill, it could descend backward while the driver switches from the brake pedal to the accelerator pedal, making it difficult for the vehicle to start off. To prevent this from occurring, the hill-start assist control temporarily (approximately 2 seconds at the maximum) applies the brakes to all the wheels in order to prevent the vehicle from descending backward.
Without the hill-start assist control, the driver must quickly and precisely switch from the brake pedal to the accelerator pedal. With the hill-start assist control, however, the driver can start off easily and operate the pedal in a relaxed manner because the hill-start assist control prevents the vehicle from descending backward.
Hill-start Assist Control Start Operation
The hill-start assist control operates when all of the following conditions have been met:
·
When on an uphill: The shift lever is in a position other than R. ·
When on a downhill: The shift lever is in a position R. ·
The vehicle is at a standstill. ·
The accelerator pedal is not depressed. ·
The parking brake is not applied. |
Hill-start Assist Control Cancelation Operation
If any one of the below conditions is met during hill-start assist control operation, hill-start assist control will be canceled.
·
When on an uphill: The shift lever is in a position R. ·
When on a downhill: The shift lever is in a position other than R. ·
The driver depresses the accelerator pedal. ·
The parking brake is applied. ·
Approximately 2 seconds elapse after the brake pedal is released. |