CONSTRUCTION
Upper Arm
The forged steel parts of the No. 1 and No. 2 upper arm from an "A" shape. The inner shaft is joined to the upper arm via bushings. A torque arm is attached to the rear of the upper arm, and the torsion bar spring is joined to the torque arm through a serration fitting. A maintenance-free sintered metal ball joint is used on the outer area of the upper arm.
Lower Arm
The forged steel parts of the No. 1 and No. 2 lower arm from an "L" shape. The No. 1 lower arm has the same maintenance-free ball joint used in the upper arm. In addition, it has bushings with inter-rings which are rigid in the lateral direction, but soft longitudinally.