Home › Engine / Hybrid System › N04C-WA (EMISSION CONTROL) › EMISSION CONTROL SYSTEM › from 2019.08
NM2850E _51 Engine / Hybrid System _083719 N04C-WA EMISSION CONTROL _0403929 EMISSION CONTROL SYSTEM DE DETAILS F

N04C-WA EMISSION CONTROL  EMISSION CONTROL SYSTEM  DETAILS  UREA PUMP  


CONSTRUCTION


a.

A urea pump is used, and is positioned in the bottom of the urea tank sub-assembly.

W144071C01
4.813,1.313 3.479,0.5 3.479,0.5 2.708,0.885 true 5.688,2.292 6.396,2.104 true 5.656,3.021 6.385,3.24 true 5.344,3.74 5.646,4.042 true 1.344,3.063 0.667,3.25 true 1.667,2.219 0.656,1.563 true 0.49,1.448 0.802,1.604 0.313,0.156 10 false *1 0.49,3.188 0.802,3.344 0.313,0.156 10 false *2 5.667,4.042 5.979,4.198 0.313,0.156 10 false *3 6.427,3.177 6.74,3.333 0.313,0.156 10 false *4 6.438,2.021 6.75,2.177 0.313,0.156 10 false *5 3.375,0.333 3.688,0.49 0.313,0.156 10 false *6
*1 Float Sensor *2 Urea Solution Temperature Sensor
*3 Pressure Sensor *4 Filter
*5 Pump Motor *6 Heater



b.

The urea pump has the following functions:

Function Outline
Pump Function While performing feedback control according to the pressure sensor inside the urea pump, the pump raises the pressure to approximately 500 kPa, sending urea solution to the urea injector set.
Heating Function The heater inside the urea pump is operated to thaw the urea solution so that exhaust gas can be purified even when the ambient temperature is low and the urea solution freezes. The heater turns on and off according to the urea solution temperature sensor inside the urea pump.
Filter Function Foreign matter that enters the urea tank sub-assembly is collected by the filter inside the urea pump, preventing foreign matter from getting jammed in the urea pump and urea injector assembly.
Level Gauge Function The fluid level position is detected by the float sensor inside the urea pump in order to detect the remaining quantity of urea solution inside the urea tank sub-assembly.